Important: the Support System for Young Researchers to Use Shared Research Equipment changed on October 1, 2026.
This page describes the former system, applicable through September 30, 2026. For the system and application process from October 1, 2026, see 【CINTS-Wide】【Policy Change】Update to the Support System for Young Researchers Using Shared Research Equipment (From October 1, 2026).
Researchers approved under the former system must reapply to use the new system.
This English page is a reference translation of the former CINTS guidance. The former procedures and application-form links below are retained as historical information; do not use them for applications under the new system.
Young researchers at Tohoku University who used equipment of the Center for Integrated Nanotechnology Support, Tohoku University (CINTS) could use the University support system. The former guidance covered equipment in the microstructure-analysis field (the Advanced Electron Microscopy Center and the Division of Analytical Electron Microscopy, IMR) and the microfabrication field (the MEMS Prototype Coin Laundry).
Under the former guidance, the young-researcher support application was entered while submitting a project application through CINTS MyPage.
Former guidance for microstructure-analysis users
Applicants who wished to use the former support system were instructed to state this in the remarks field of the project application form and, after project selection, complete and submit the relevant application form to the office.
Former guidance for microfabrication users
Before applying for a project, applicants were asked to contact the μSIC Support Office at micro-shien@grp.tohoku.ac.jp. The former application was entered during the CINTS MyPage project application.
※This English historical reference was created by an AI agent.

